632 research outputs found
Development of closed loop roll control for magnetic balance systems
This research was undertaken with the goal of demonstrating closed loop control of the roll degree of freedom on the NASA prototype magnetic suspension and balance system at the MIT Aerophysics Laboratory, thus, showing feasibility for a roll control system for any large magnetic balance system which might be built in the future. During the research under this grant, study was directed toward the several areas of torque generation, position sensing, model construction and control system design. These effects were then integrated to produce successful closed loop operation of the analogue roll control system. This experience indicated the desirability of microprocessor control for the angular degrees of freedom
Application of digital control to a magnetic model suspension and balance model
The feasibility of using a digital computer for performing the automatic control functions for a magnetic suspension and balance system (MSBS) for use with wind tunnel models was investigated. Modeling was done using both a prototype MSBS and a one dimensional magnetic balance. A microcomputer using the Intel 8080 microprocessor is described and results are given using this microprocessor to control the one dimensional balance. Hybrid simulations for one degree of freedom of the MSBS were also performed and are reported. It is concluded that use of a digital computer to control the MSBS is eminently feasible and should extend both the accuracy and utility of the system
Application of superconducting coils to the NASA prototype magnetic balance
Application of superconducting coils to a general purpose magnetic balance was studied. The most suitable currently available superconducting cable for coils appears to be a bundle of many fine wires which are transposed and are mechanically confined. Sample coils were tested at central fields up to .5 Tesla, slewing rates up to 53 Tesla/ sec and frequencies up to 30 Hz. The ac losses were measured from helium boil-off and were approximately 20% higher than those calculated. Losses were dominated by hysteresis and a model for loss calculation which appears suitable for design purposes is presented along with computer listings. Combinations of two coils were also tested and interaction losses are reported. Two feasible geometries are also presented for prototype magnetic balance using superconductors
A comparison of similar aerosol measurements made on the NASA P3-B, DC-8, and NSF C-130 aircraft during TRACE-P and ACE-Asia
Two major aircraft experiments occurred off the Pacific coast of Asia during spring 2001: the NASA sponsored Transport and Chemical Evolution over the Pacific (TRACE-P) and the National Science Foundation (NSF) sponsored Aerosol Characterization Experiment-Asia (ACE-Asia). Both experiments studied emissions from the Asian continent (biomass burning, urban/industrial pollution, and dust). TRACE-P focused on trace gases and aerosol during March/April and was based primarily in Hong Kong and Yokota Air Force Base, Japan, and involved two aircraft: the NASA DC-8 and the NASA P3-B. ACE-Asia focused on aerosol and radiation during April/May and was based in Iwakuni Marine Corps Air Station, Japan, and involved the NSF C-130. This paper compares aerosol measurements from these aircraft including aerosol concentrations, size distributions (and integral properties), chemistry, and optical properties. Best overall agreement (generally within RMS instrumental uncertainty) was for physical properties of the submircron aerosol, including condensation nuclei concentrations, scattering coefficients, and differential mobility analyzer and optical particle counter (OPC) accumulation mode size distributions. Larger differences (typically outside of the RMS uncertainty) were often observed for parameters related to the supermicron aerosols (total scattering and absorption coefficients, coarse mode Forward Scattering Spectrometer Probe and OPC size distributions/integral properties, and soluble chemical species usually associated with the largest particles, e.g., Na+, Cl−, Ca2+, and Mg2+), where aircraft sampling is more demanding. Some of the observed differences reflect different inlets (e.g., low-turbulence inlet enhancement of coarse mode aerosol), differences in sampling lines, and instrument configuration and design. Means and variances of comparable measurements for horizontal legs were calculated, and regression analyses were performed for each platform and allow for an assessment of instrument performance. These results provide a basis for integrating aerosol data from these aircraft platforms for both the TRACE-P and ACE-Asia experiments
Recommended from our members
Aerosol physical properties and processes in the lower marine boundary layer: A comparison of shipboard sub-micron data from ACE-1 and ACE-2
The goals of the IGAC Aerosol Characterization Experiments (ACE) are to determine and understand the properties and controlling processes of the aerosol in a globally representative range of natural and anthropogenically perturbed environments. ACE-1 was conducted in the remote marine atmosphere south of Australia while ACE-2 was conducted in the anthropogenically modified atmosphere of the Eastern North Atlantic. In-situ shipboard measurements from the RV Discoverer(ACE-1) and the RV Professor Vodyanitskiy(ACE-2), combined with calculated back trajectories can be used to define the physical properties of the sub-micron aerosol in marine boundary layer (MBL) air masses from the remote Southern Ocean, Western Europe, the Iberian coast, the Mediterranean and the background Atlantic Ocean. The differences in these aerosol properties, combined with dimethylsulfide, sulfur dioxide and meteorological measurements provide a means to assess processes that affect the aerosol distribution. The background sub-micron aerosol measured over the Atlantic Ocean during ACE-2 was more abundant (number and volume) and appeared to be more aged than that measured over the Southern Ocean during ACE-1. Based on seawater DMS measurements and wind speed, the oceanic source of non-sea-salt sulfur and sea-salt to the background marine atmosphere during ACE-1 and ACE-2 was similar. However, the synoptic meteorological pattern was quite different during ACE-1 and ACE-2. The frequent frontal passages during ACE-1 resulted in the mixing of nucleation mode particles into the marine boundary layer from the free troposphere and relatively short aerosol residence times. In the more stable meteorological setting of ACE-2, a significant nucleation mode aerosol was observed in the MBL only for a half day period associated with a weak frontal system. As a result of the longer MBL aerosol residence times, the average background ACE-2 accumulation mode aerosol had a larger diameter and higher number concentration than during ACE-1. The sub-micron aerosol number size distributions in the air masses that passed over Western Europe, the Mediterranean, and coastal Portugal were distinctly different from each other and the background aerosol. The differences can be attributed to the age of the air mass and the degree of cloud processing
Some Additive Combinatorics Problems in Matrix Rings
We study the distribution of singular and unimodular matrices in sumsets in
matrix rings over finite fields. We apply these results to estimate the largest
prime divisor of the determinants in sumsets in matrix rings over the integers
Catalog of Functions for Computer-Based Traffic Signal Systems
DTFH61-83-C-00003The catalog of functions includes a description of a "Basic" computer-based traffic signal system, plus a listing and description of options which can be added. Standardization of the functional requirements of the Basic system, and of the functional requirements for additional features (options), will assist planners and users in the functional design of their systems, as well as assist designers in the design of hardware and software components and modules. Standardization of performance functions, as well as compatibility of equipment that implements these functions, is a major consideration. The catalog of functions contains: (1) A description of the Basic system, plus options; (2) Traffic performance, utility considerations, and cost factors associated with each option; (3) A cross-reference between the catalog of functions and the functional specifications. Functional specifications describe what functions are to be performed, parameters to be measured and/or displayed, and inputs and outputs associated with each function. The functional specifications do not define how each function is to be specifically translated into hardware or software elements
Prospecting environmental mycobacteria: combined molecular approaches reveal unprecedented diversity
Background: Environmental mycobacteria (EM) include species commonly found in various terrestrial and aquatic environments, encompassing animal and human pathogens in addition to saprophytes. Approximately 150 EM species can be separated into fast and slow growers based on sequence and copy number differences of their 16S rRNA genes. Cultivation methods are not appropriate for diversity studies; few studies have investigated EM diversity in soil despite their importance as potential reservoirs of pathogens and their hypothesized role in masking or blocking M. bovis BCG vaccine.
Methods: We report here the development, optimization and validation of molecular assays targeting the 16S rRNA gene to assess diversity and prevalence of fast and slow growing EM in representative soils from semi tropical and temperate areas. New primer sets were designed also to target uniquely slow growing mycobacteria and used with PCR-DGGE, tag-encoded Titanium amplicon pyrosequencing and quantitative PCR.
Results: PCR-DGGE and pyrosequencing provided a consensus of EM diversity; for example, a high abundance of pyrosequencing reads and DGGE bands corresponded to M. moriokaense, M. colombiense and M. riyadhense. As expected pyrosequencing provided more comprehensive information; additional prevalent species included M. chlorophenolicum, M. neglectum, M. gordonae, M. aemonae. Prevalence of the total Mycobacterium genus in the soil samples ranged from 2.3×107 to 2.7×108 gene targets g−1; slow growers prevalence from 2.9×105 to 1.2×107 cells g−1.
Conclusions: This combined molecular approach enabled an unprecedented qualitative and quantitative assessment of EM across soil samples. Good concordance was found between methods and the bioinformatics analysis was validated by random resampling. Sequences from most pathogenic groups associated with slow growth were identified in extenso in all soils tested with a specific assay, allowing to unmask them from the Mycobacterium whole genus, in which, as minority members, they would have remained undetected
Achieving Stability of Lipopolysaccharide-Induced NF-κB Activation
The activation dynamics of the transcription factor NF-κB exhibit damped oscillatory behavior when cells are stimulated by tumor necrosis factor–α (TNFα) but stable behavior when stimulated by lipopolysaccharide (LPS). LPS binding to Toll-like receptor 4 (TLR4) causes activation of NF-κB that requires two downstream pathways, each of which when isolated exhibits damped oscillatory behavior. Computational modeling of the two TLR4-dependent signaling pathways suggests that one pathway requires a time delay to establish early anti-phase activation of NF-κB by the two pathways. The MyD88-independent pathway required Inferon regulatory factor 3–dependent expression of TNFα to activate NF-κB, and the time required for TNFα synthesis established the delay
- …